Windshield
The windshield wiper and washer can only operate when the ignition is on. Press the switch down to select the operating mode:
- ① Intermittent operation The wiper speed is adjusted by turning the knob in the direction Ⓐ - slow down or Ⓑ - accelerate
- ② Low frequency continuous operation
- ③ High frequency continuous operation
- ④ Wiper single pass: move the lever up
- ⑤ Turn on the washer: pull the lever towards you. At the same time as the washer, the windshield wiper will make several passes
Rain sensor (if available)
The rain sensor is activated if the wiper switch is in the intermittent Ⓘ operating mode position (AUTO mode).
When water drops are detected on the windshield, the rain sensor activates the wiper, the frequency of which will depend on the intensity of the rain.
Rear glass
The rear window wiper and washer can only operate when the ignition is on. Turn the switch knob clockwise to turn on the intermittent - ① or continuous - ② operation of the rear window wiper.
Push the lever away from you ③ to turn on the rear window washer. At the same time as the washer, the rear window wiper is also switched on.
Attention:
- Do not operate the windshield washer continuously for more than 15 seconds.
- Do not operate the windshield washer if the washer reservoir is empty or frozen.
- When the ambient temperature is below zero, the liquid supplied to the rear window from the washer nozzles may freeze and impair visibility. Before using the washer, it is recommended to heat the rear window by turning on the electric heater.
Note: If the windshield wiper switch is in the intermittent or continuous position (slow or fast) operating mode, when the reverse gear is engaged, the rear window wiper is switched on (if available).