Drive shafts and hubs of the car Nissan Micra 3 (K12)

Specifications for drive shafts and hub assemblies
Type of outer // inner CV joint Z80 // T70C Amount of lubrication of the outer // inner CV joint, g±5 50 // 115 The length of the anthers of the outer // inner CV joint,...

General information about drive shafts and hub assemblies
The vehicles covered in this manual are front-wheel drive. Torque is transmitted to the wheels from the differential through the drive shafts. Variable angle of...

Removal and installation of a rotary fist
Steering knuckle assembly 1 - Swivel fist; 2 - Wheel sensor housing; 3 - Wheel bearing; 4 - Retaining ring; 5 - Hub; 6 - Drive shaft 1. Jack up the car and put it on...

Replacement of anthers of power shafts
Note. The following describes how to replace the driveshaft boots without removing the driveshafts from the vehicle. 1. Jack up the car and put it on stands. Remove the...

Removal and installation of power shafts
1. Follow the steps described in paragraphs 1-7 . 2. Disconnect the drive shaft from the transmission using, for example, a wheel nut wrench. 3. Carefully remove the...

Disassembly and assembly of drive shafts
The right drive shaft assembly components are shown in the illustration below. There is no vibration damper on the left drive shaft. Assembly components of the right...

Removal and installation of the hub assembly of the rear wheel
Hub assembly 1 - Back plate; 2 - Spindle; 3 - ABS wheel sensor rotor; 4 - Wheel bearing; 5 - Retaining ring; 6 - Brake drum; 7 - Hub nut cap 1. Jack up the car and put...