2. Remove the locker of the right front wheel arch (see chapter Body).
3. Remove the alternator drive belt (see Section Replacing accessory drive belts and intermediate belt rollers).
4. Turn out bolts of fastening of an arm of an intermediate roller and remove assembly of a roller.
5. Separate a socket of an electroconducting of the generator. Give the terminal nut «B», the ground wire nut and remove the electrical wiring holders.
6. Remove a rack of a support of the engine from the right side.
7. Turn out a bolt of fastening of the top arm of the generator, and also the top bolt of fastening of the generator.
8. Turn out the bottom bolt of fastening of the generator and take a bolt from a U-shaped groove. On the front cover of the generator.
9. Remove the generator from the car.
10. Installation is carried out in the reverse order. Observe the tightening torque of the fasteners, after installation, check and, if necessary, adjust the tension of the alternator drive belt (see Section Checking the condition of the accessory drive belt and adjusting its tension).