Note. A description of the adjustment of the parking brake is given in Section Checking the brake system and clutch.
Parking brake actuator components
1 - Assembly of the lever; 2 - Screw; 3 - Sensor; 4 - Adjusting nut; Front cable: 5 - Equalizer; 6/7 - Rear left/right cable
1. Remove the console between the seats (see chapter Body).
2. Disconnect the parking brake applied sensor connector.
3. Give an adjusting nut and disconnect forward and back cables.
4. Give nuts of fastening of assembly of the lever of a parking brake.
5. Remove the brake pads (see Section Removal and installation of assembly of back brake mechanisms) and disconnect the cable from the drive arm.
6. Remove the central section of the exhaust pipe and the heat shield.
7. Give fixture of arms of cables and remove arms.
8. Installation is carried out in the reverse order. Finally, adjust the parking brake.