Brake system of the car Nissan Micra 3 (K12)

Brake Specifications
General information Brake system With double diagonal contour separation, front disc (with single piston calipers) and rear drum brakes Type of brake fluid FMVSS 116 DOT...

General information and security measures
General information The front wheels of the vehicles considered in this Manual are equipped with disc brakes. Brake discs are ventilated. Drum brakes are installed on...

Removal and installation of brake lines
Scheme of laying brake lines 1. Drain the brake fluid (see Section Changing the brake fluid and bleeding the brake system ). 2. At the rear of the car, use a wrench to...

Removing and installing the brake pedal
Brake Pedal Mounting Components 1 - Cotter pin; 2 - D / V stop lights; 3 - Retainer; 4 - Assembling the brake pedal; 5 - Axial pin 1. Remove the instrument panel trim...

Removal and installation of GTZ
GTZ Assembly Components 1 - Locking cap; 2 - Assembly of the primary piston; 3 - Brake fluid level sensor connector; 4 - Clutch hose (models with manual transmission); 5...

Removal and installation of the vacuum amplifier
Vacuum booster mounting components 1. Disconnect the vacuum hose from the vacuum booster. 2. Remove GTZ (see Section Removal and installation of GTZ ). 3. Remove the...

Replacing the brake pads of the front wheels
Note. Pads should be replaced simultaneously on both wheels of the same axle (those. 4 pads). Front brake components 1 - Anchor bracket; 2 - Guide pin; 3 - Bellow; 4/5 -...

Removal and installation of forward brake mechanisms and disks
Front brake assembly components are shown in the illustration Front brake components . 1. Jack up the vehicle and remove the relevant wheel. 2. Drain the brake fluid...

Removal and installation of assembly of back brake mechanisms
Removing Rear brake assembly components 1 - Drum; 2/3 - Lower / upper coupling spring; 4 - Expanding bar; 5 - Retainer; 6 - Block; 7 - Wheel cylinder; 8 - bleed valve; 9...

Removal and installation of a drive of a parking brake
Note. A description of the adjustment of the parking brake is given in Section Checking the brake system and clutch . Parking brake actuator components 1 - Assembly of...

Removal and installation of components of system ABS
The location of the ABS components is indicated in the illustration Location of components of auxiliary systems . Components for installing an activator and an ABS...