MR20DE engines (SCL, CVT) and QR25DE (MCP). 1. Main gear assembly; 2. Front oil seal; 3. Connecting flange; 4. Lock nut of the connecting flange; A. Oil seal lip.
Engine QR2BOE (CVT). 1. Main gear assembly; 2. Front oil seal; 3. Connecting flange; 4. Lock nut of the connecting flange; A. Oil seal lip.
Removal and installation
Removal
1. Remove the rear driveshaft. See below.
2. Apply an alignment mark to the threaded end of the electronic coupling. The mark must match the mark on the connecting flange.
Attention. Apply marks with paint. Do not damage the electrical coupling. management.
3. Using a flange wrench (suitable special tools) Unscrew the lock nut of the connecting flange and remove the connecting flange.
4. Remove the front oil seal from the clutch cover using a flat blade screwdriver.
Attention. Do not damage the coupling cover.
Installation
1. Press in the front oil seal using drifts so that it is flush with the end surface of the clutch cover.
A. Punch (special tool KV38100200); V. Punch (special tool ST27861000)
Attention:
- Do not reuse the seal.
- When pressing, do not allow the oil seal to skew.
- Apply multi-purpose grease to the seal lips and gear oil around the seal circumference.
2. Align the marks on the electronic coupling with the connecting flange and attach the connecting flange.
3. Using a flange wrench (suitable special tools) Place the locknut on the connecting flange and tighten to the required torque.
Attention. Do not reuse the connection flange locknut.
4. Attach the rear propeller shaft. See above.
5. If there was any oil leakage during removal, check the oil level after installation. See above.