1. Valve cover; 2. Ignition coil; 3. Spark plug; 4. Gasket; A. See below
Removal and installation
Removal
1. Remove the ignition coils. See below.
2. Remove the spark plugs using a wrench (suitable special tools)
Key with magnet for holding spark plug
Attention. Do not drop or hit spark plugs.
Installation
Installation is performed in the reverse order of removal.
Check after removal
Under normal operating conditions, use standard spark plugs.
Spark plug (standard). See below.
Attention:
- Do not drop or strike the spark plugs.
- Do not clean with a wire brush.
- If there is carbon deposits on the tip of the spark plug, you can use spark plug cleaner.
Air pressure in the purifier.
Less than 588 kPa (6 kg/cm³).
Cleaning time: Less than 20 seconds.
- It is not necessary to check and adjust the spark gap between replacements.
