Examination
Leak check
Make sure there are no oil leaks from the manual transmission and surrounding areas.
Level check
1. Remove the plug (1).
2. Measure the oil level using a suitable dipstick (A), as shown in the figure and make sure it is within the normal range.
Oil level «L»: See chapter "Clutch and manual transmission".
Attention:
- Do not start the engine while checking the oil level.
- Measure the oil level using a suitable dipstick through the hole under the filler plug.
3. Place a new O-ring on the filler plug and screw it into the transmission housing.
Attention. Do not reuse the O-ring.
4. Tighten the plug mounting bolt to the required torque.
Oil drain
1. Start the engine and warm up the gearbox.
2. Stop the engine. Remove the drain plug and drain the transmission oil.
3. Place a new gasket on the drain plug and screw it into the clutch housing.
- Tighten to the required torque.
Attention. Do not reuse the gasket.
Oil filling
1. Remove the plug (1). Pour fresh transmission oil into the gearbox.
Oil brand and viscosity: See above. Oil filling capacity (standard). See chapter "Clutch and manual transmission".
2. After refueling, check the oil level. See above.
3. Place a new O-ring on the drain plug and screw it into the clutch housing.
Attention. Do not reuse the O-ring.
4. Tighten the plug mounting bolt to the required torque.