Windshield wiper levers. 1. Right wiper brush; 2. Right wiper lever; 3. Wiper lever cap; 4. Left wiper brush; 5. Left wiper lever.
Removal and installation
Removal
1. Turn on the engine with the wiper switch and then turn it off (hitch-hiking).
2. Open the hood.
3. Remove the caps from the wiper arms.
4. Unscrew the fastening nuts of the wiper arms.
5. Lift the wiper arms and remove them from the vehicle.
Installation
1 Clean the area where the wiper arm attaches to the axle as shown in the illustration. This will eliminate the possibility of loosening the nuts.
2. Turn on the engine with the wiper switch and then turn it off (hitch-hiking).
3. Adjust the position of the wiper blades. See below.
4. Install the wiper arms by tightening the mounting nuts.
5. Wet the glass with cleaning liquid.
6. Turn on the engine with the wiper switch and then turn it off (hitch-hiking).
7. Make sure the wiper blades stop in the correct position.
8. Place the caps on the wiper arms.
Adjustment
Adjusting the stop position of the wiper brushes
The gap between the edge of the hood grille cover and the top center of the wiper blade.
Standard clearance. «R»: 34.1±7.5 mm; «L»:39.7±7.5 mm