Washer reservoir

Removal and installation

Removal

1. Take out the clamp (A).



2. Remove the inlet pipe (1) from the tank.

3. Remove the protective trim from the right front fender. See chapter «Interior and exterior equipment».

4. Disconnect the connector from the washer pump.

5. Disconnect the connector from the headlight washer pump.

6. Disconnect the tubes from all washers.

7. Unscrew the washer reservoir mounting bolts.

8. Remove the washer reservoir from the vehicle.

Installation

Installation is carried out in the reverse order of removal.

Attention. After installation, add water to the upper level of the washer reservoir inlet pipe and check for water leaks.