Attention:
- If the light and rain sensor is removed from the windshield, do not reuse the housing surface for gluing.
- When reusing the light and rain sensor (eg after replacing the windshield) Replace the light and rain sensor housing.
Withdrawal. 1. Light and rain sensor connector; 2. Top cover of the interior mirror; 3. Bottom cover of the interior mirror; 4. Light and rain sensor; A. Metal spring clip.
Disassembly. 1. Light and rain sensor housing; 2. Light and rain sensor; A. Latch.
Attention. Do not touch the electronic circuit board.
Removal and installation
- If you remove the light and rain sensor from the windshield, do not reuse the housing surface for gluing.
- When reusing the light and rain sensor (eg after replacing the windshield) Replace the light and rain sensor housing.
Removal
1. Remove the top and bottom covers of the interior mirror. See section above «Mirrors».
2. Disengage the metal spring clips on both sides and remove the light and rain sensor from the windshield.
3. Disconnect the connector from the light and rain sensor.
Note:
- If replacing the light and rain sensor housing, disengage the latches and remove the housing from the light and rain sensor.
- Do not touch the electronic circuit board.
Installation
Installation is carried out in the reverse order of removal.
Attention:
- Clean the soldering surface on the windshield.
- Do not touch the glue.