Removal
Follow steps 1-17. «Removal» higher.
Installation
Installation is carried out in the reverse order of removal, taking into account the following:
- Perform final tightening of all components removed when removing the rear suspension beam in an unloaded condition.
- Check whether the wheel sensor wiring is connected correctly. See chapter «Brake system».
Check after removal
Check the rear suspension beam for deformation, cracks or other damage. Replace if necessary.
Check after installation
1. Adjust the parking brake (stroke length). See chapter «Brake system».
2. Check the rear wheel alignment angles. See above.
3. Adjust the neutral position of the steering angle sensor. See chapter «Brake system».