2WD Models — Vehicle Service Rear wheel hub and rear axle housing Checking fastening elements Make sure that the condition of the fastening elements (backlash, gap) all components and condition of...
2WD models — on-vehicle repairs Rear wheel hub 1. Suspension arm; 2. Dirt shield; 3. Wheel hub and wheel bearing assembly. Removal Wheel hub and wheel bearing assembly 1. Remove the wheels from the...
4WD Models — Vehicle Service Rear wheel hub and front axle housing Checking fastening elements Make sure that the condition of the marking elements (backlash, gap) all components and condition of...
Technical data and specifications of drive shafts 2WD models Wheel bearings Axial play 0.05mm or less 4WD models Wheel bearings Axial play 0.05mm or less Drive shafts Hinge Wheel side From the main gear side Lubricant...
On-Vehicle Service — Rear Suspension Assembly Checking fastening elements Make sure that the condition of the fastening elements (play, clearance), all components and condition of components (wear damage) correspond...
On-vehicle servicing — checking rear wheel alignment Description Measure the rear wheel alignment angles when unloaded. Note. «Unloaded» This condition means that the vehicle is fully filled with fuel, coolant and engine...
Car repair — spring Spring 1. Rear suspension beam; 2. Suspension beam protection (2WD); 3. Suspension beam strut (on the right side); 4. Suspension beam strut (on the left side); 5....
Car repair — rear shock absorber Removal 1. Remove the wheels from the vehicle. 2. Support the suspension arm with a suitable jack and remove the load from the spring. 3. Remove the shock absorber....
Car repair — suspension arm Removal 1. Remove the wheels from the vehicle. 2. Drain the brake fluid. See chapter « Brake system ». 3. Remove the mounting bolts from the caliper bracket. Hang the...
Car repair — control rod Removal 1. Remove the wheels from the vehicle. 2. Support the suspension arm with a suitable jack and remove the load from the spring. 3. Remove the automatic headlight...
Repair on a car — wishbone Removal 1. Remove the wheels from the vehicle. 2. Remove the wheel sensor wiring from the suspension arm. 3. Support the suspension arm with a suitable jack and remove...
On-car service — rear stabilizer bar Removal 1. Remove the stabilizer connecting rod. 2. Remove the main muffler. See chapter « Accelerator, fuel and exhaust systems ». 3. Unscrew the fixing nuts of the...
Car repair — rear suspension beam Removal 1. Remove the wheels from the vehicle. 2. Remove the mounting bolts from the caliper bracket. Hang the caliper bracket so that it does not interfere with your...
Car repair — rear suspension assembly Removal Follow steps 1-17. « Removal » higher. Installation Installation is carried out in the reverse order of removal, taking into account the following: Perform final...
Rear suspension technical data and specifications Rear wheel alignment angles Camber degrees minutes (decimal degrees) Minimum -1’20 (1,33’) Denomination -0'50 (0,83') Maximum 0’20 (-0,33') Overall toe Distance Minimum...