Car front suspension Nissan X-Trail 2 (T31)

Front axle 2WD model — on-vehicle service
Front wheel hub Checking fastening elements Make sure that the condition of the fastening elements (backlash clearance) all components and condition of components (wear...

2WD models — on-vehicle repairs
Front wheel hub and steering knuckle 1. Steering knuckle; 2. Dirt shield; 3. Wheel hub and wheel bearing assembly; 4. Cotter pin. Removal Wheel hub and wheel bearing...

4WD Models — Vehicle Service
Front wheel hub and steering knuckle Checking fastening elements Make sure that the condition of the fastening elements (backlash, gap) all components and condition of...

4WD models — on-vehicle repairs
Front wheel hub and steering knuckle. 1. Steering knuckle; 2. Dirt shield; 3. Wheel hub and wheel bearing assembly; 4. Cotter pin. Removal Wheel hub and wheel bearing...

Models 4WD car repairs — front drive shaft covers
Removal On the left side. 1. Drive shaft; 2. Cotter pin. On the right side (engine MR20DE) 1. Cotter pin; 2. Drive shaft; 3. Plate; 4. Support bearing bracket. On the...

Front drive shafts (Engine MR20DE)
Removal from the left side. 1. Drive shaft; 2. Cotter pin. Removal from the right side. 1. Cotter pin; 2. Drive shaft; 3. Plate; 4. Support bearing bracket. Disassembly...

Front drive shafts (Engine QR25DE)
Removal from the left side 1. Drive shaft; 2. Cotter pin. Removal from the right side 1. Cotter pin; 2. Drive shaft; 3. Plate; 4. Support bearing bracket. Disassembly...

Technical data and specifications of drive shafts
2WD models Wheel bearings Axial play 0.05mm or less Drive shafts Engine MR20DE Hinge Wheel side Transmission side Lubricant quantity On the left side 115-135 g 200-220 g...

On-Vehicle Service — Front Suspension Assembly
Checking fastening elements Make sure that the condition of the fastening elements (backlash clearance) all components and condition of components (wear damage)...

Checking the front wheel alignment angles
Description Attention: The camber, longitudinal and transverse inclination angles of the turning axis cannot be adjusted. If the camber, pitch and roll angles of the...

Car repair — spring and strut
Spring and strut. 1. Rack mounting insulator; 2. Bearing for mounting the strut; 3. Bumper; 4. Spring; 5. Bottom rubber socket; 6. Stand; 7. Plug; 8. Steering knuckle;...

Wishbone
Removal 1. Remove the wheels from the vehicle. 2. Separate the wishbone from the steering knuckle. 3. Remove the wishbone from the suspension beam. Note. The wishbone...

Anti-roll bar
Removal 1. Remove the wheels from the vehicle. 2. Separate the outer tie rod ends from the steering knuckle. See chapter « Steering ». 3. Remove the stabilizer...

Front suspension beam
Removal 1. Remove the wheels from the vehicle. 2. Remove the engine protection from the bottom. 3. Remove the wheel sensor from the steering knuckle. See chapter « Brake...

Front suspension assembly
Removal Follow steps 1-13. « Removal » higher. Installation Installation is carried out in the reverse order of removal, taking into account the following: Perform final...

Front suspension technical data and specifications
Front wheel alignment angles Camber degrees minutes (decimal degrees) Minimum 1°15' (-1.25°) Denomination -0°30' (-0,50°) Maximum 0°15' (0,25°) Difference left and right...