Vacuum brake booster — performance check Press the brake pedal several times at 5-second intervals with the engine off. Then, pressing the brake pedal all the way, start the engine. Make sure that the gap...
Vacuum brake booster — leak check Start the engine and let it run at idle speed. about 1 minute, applying vacuum to the amplifier. Turn off the engine. Then press the brake pedal several times at 5...
Front wheel disc brakes — checking pad wear Check the thickness of the pads through the inspection hole in the cylinder body. Use a ruler if necessary. Standard thickness. See section below « Technical data and...
Front wheel disc brakes — checking the brake disc Checking the appearance Check the surface of the brake rotor for uneven wear, cracks or serious damage. Replace if necessary. Runout check 1. Secure the brake disc to...
Rear disc brakes — checking pad wear Check the thickness of the pads through the inspection hole in the cylinder body. If necessary, use a ruler. Standard Thickness: See section below « Technical data and...
Rear disc brakes — checking the brake disc Checking the appearance Check the surface of the brake disc for uneven wear, cracks and serious damage. Replace if necessary. Runout check 1. Secure the brake disc to...
Brake pedal — checking and adjustment Check after removal Check the following components and, if necessary, replace the brake pedal assembly: Are the rivets deformed? (A) at the top of the brake pedal; is...
Brake pipes and hoses Hydraulic circuit Engines MR20DE and QR25DE. 1. ABS actuator and control unit; 2. Front wheel disc brake; 3. Master cylinder assembly; 4. Vacuum brake booster; 5....
Rear disc brakes Rear wheel disc brakes. 1. Brake pipe; 2. Locking plate; 3. Brake hose; 4. Brake hose bracket; 5. Connecting bolt; A. To the brake hose of the front wheels; B. To the...
Master brake cylinder — disassembly and assembly Disassembly Attention: The cylinder body cannot be disassembled. Remove the reservoir only if necessary. 1. Secure the master cylinder assembly in a vice. Attention....
Vacuum brake booster — checking and adjustment Check after removal Checking the length of the protruding part of the rod 1. Using a hand-held vacuum pump, create a vacuum of -66.7 kPa in the brake booster (-500...
Vacuum Tubes and Hoses — MR20DE Engine Engine MR20DE 1. Clamp; 2. Vacuum hose; 3. Vacuum tube; 4. Clamp; 5. Vacuum hose (with built-in stop valve); A. To the intake manifold; B. To the brake booster; C. Paint...
Vacuum Tubes and Hoses — QR25DE Engine Engine QR25DE. 1. Clamp; 2. Vacuum hose; 3. Vacuum tube; 4. Clamp; 5. Vacuum hose (with built-in stop valve); A. To the intake manifold; B. To the brake booster; C....
Brake system technical data and specifications General information Unit of measurement: mm. Front wheel brakes Cylinder diameter 60,33 Length x width x pad thickness 123.6 x 47.5 x 11 0 Outer diameter x disc...
Car Repair — Parking Brake Control Parking brake control. 1. Regulator hole plug; 2. Adjusting nut; 3. Parking brake lever assembly; 4. Front cable; 5. Rear left cable; 6. Rear right cable. Removal and...
Parking brake technical data and specifications Parking brake drum Friction lining Standard thickness 3.2 mm Wear limit 1.5 mm Drum. (disk) Standard internal diameter 172 mm Wear limit 173 mm Parking brake control...