Wing protective pad. 1. Front fender protective trim; 2. Mudguard; 3. Front fender; 4. Lower protective trim of the front fender; 5. J-nut; 6. Rubber bushing; 7. Wing clamp.
Removal and installation
Removal
1. Remove the front corner molding and front mudguard. See below.
2. Remove the mounting clips (A) from the splash guard.
3. Remove the mounting clips from the front fender guard.
4. Remove the mounting screws from the front fender protective trim.
5. Disengage the upper mounting clips from the bottom of the front fender skid plate, then remove the skid plate.
6. After removing the fender guard, remove the following components:
- lower protective trim of the front fender,
- splash guard
Installation
Installation is carried out in the reverse order of removal.
Attention. When installing the fender skid plate, check that the clips are positioned correctly over the holes in the body panel, then press them in.