4.1A. Loosen the cable adjuster locknut...
4.1V... and unscrew the regulator nut, if necessary...
4.1C... until the cable can be disconnected from the release lever
2. Release the cable from the hangers on the clutch housing and the bulkhead, then unscrew the two nuts securing the cable to the bulkhead (photo).
4.2A. Release the cable from the bulkhead suspension...
4.2V... and unscrew the two nuts (marked with arrows) release cable supports
3. From inside the car, unscrew the four screws, remove the lower panel under the steering column, then disconnect the end of the cable from the clutch pedal. Push it into the engine compartment and pull it forward through the hole in the bulkhead.
4. Check the condition of the cable. Check the operation of the cable; The inner wire should move smoothly and easily in the outer casing. Replace the cable if it is worn or damaged. Do not use lubricant when trying to repair a worn cable.
5. Installation is carried out in reverse order, apply a thin layer of the specified lubricant to the end of the cable (photo).
4.5. Lubricate the end of the cable and check the adjustment
Guided by Chapter 2 from this Section, adjust the cable.