Automatic Transmission — Specifications General characteristics Type - Transformer with locking system, two planetary gears giving four forward gears (including overdrive) and reverse gear, integrated final...
General description of automatic transmission Pic. 7.1 Automatic transmission RL4F02A: 1. Clutch housing; 2. Torque converter; 3. Oil pump; 4. Reverse clutch; 5. Increased coupling; 6. Freewheel; 7. Front planetary...
Automatic transmission maintenance 1 With the frequency given in Section " Maintenance " At the beginning of this Manual, carefully inspect the transmission connecting surfaces and seals. 2 Check the...
Transmission fluid — check Note: To accurately determine the transmission fluid level, the engine and transmission must be warmed up to normal operating temperature (about 70°C). Checking the...
Transmission fluid — replacement Note: The amount of liquid indicated in this Section is general, i.e. fluid in the torque converter (approximately 2 liters), in part of the radiator heat exchanger and...
Lowering cable (kickdown) — adjustment 1. The cable adjustment must be checked every time. when the accelerator cable or idle speed is adjusted. 2. First check the accelerator cable adjustment. 3. Loosen the...
Lowering cable — removal and installation 1. Loosen both lowering cable locknuts ('A' and 'B', Fig. 7.5) on the upper end of the cable, on each side of the accelerator cable hanger. Disconnect the outer cable...
Gear shift mechanism — checking and adjustment 1. If, during regular monitoring specified in " Maintenance ", the gear selector cannot be felt to be locked, or the engaged gear does not correspond to that indicated...
Rod and gear shift cable — removal and installation 1. Apply the handbrake, set the lever to position "R", lift up the front of the car. 2. Remove the spring clamp and disconnect the cable from the gear selection lever....
Selector lever — removal and installation 1. Apply the handbrake, set the lever to position "R". 2. Remove the central console. 3. Disconnect the overdrive button and electrical wiring. Remove the select lever...
Speedometer drive — removal and installation Pic. 7.14. Assembling the speedometer housing and drive 1. Open the hood, disconnect the speedometer drive cable from the transmission. See Section 12 . 2. If required,...
Oil seals — replacement Differential side seals 1. Drain the transmission fluid and remove the drive shaft (shafts) and fender liner (wheel arch liners), as described in Section 8 . 2. Remove...
Transmission Fluid Cooler — General Description 1. During driving, the transmission heats up to a high temperature, which must be reduced to prevent deterioration of the fluid and damage to the transmission. For this...
Transmission — removal and installation Note: If the transmission is being removed for repair, check it in the vehicle first. Some tools will be required to support the weight of the transmission. 1. Park the...
Troubleshooting — Automatic Transmission In the event of transmission damage not related to the fluid level or adjustments described in this Section, the nature of the damage must first be determined:...