Generator — description and precautions 1. The generator produces alternating current, which is rectified by diodes; the voltage regulator controls the output characteristics. 2. The generator consists of two...
Charging system/alternator — vehicle check 1. If the system is operating correctly, the warning lamp on the dashboard will light up when the ignition is turned on (how to check work) and turns off as soon as the...
Generator — removal and installation 1. Disconnect the negative battery cable. 2. Disconnect the generator wiring. Unscrew the nut and gasket, release the ground wiring, disconnect the multi-pin plug from...
Generator brushes and voltage regulator — replacement Generator Mitsubishi Pic. 12.1. Generator Mitsubishi 1. Remove the generator as described above. 2. Unscrew the pulley nut, remove the spring washer, pulley and metal...
Generator — bulkhead 1. The information given in this manual is limited to checking and replacing brushes and voltage regulator. 2. Always check the drive belt and brush holder/voltage...
Starter — checking on the car 1. If the starter stops working properly, first check the condition of the battery, including the headlights. If they start out bright and then gradually dim after a few...
Starter — removal and installation 1. Disconnect the negative battery cable. 2. Remove the pipe system and/or air filter. 3. Disconnect the battery and switch wire from the clamp "IN" to the starter...
Starter — bulkhead 1. Remove the starter as described above. 2. Clean the block from dirt. Checking the traction relay - all types 3. Before checking the traction relay, disconnect the...
Relay — general description 1. The relays are located in two main groups: in a holder installed on the right side of the engine compartment, or above the fuse panel, behind it. Multiple relays...