Body — general description Note: Always disconnect the negative battery cable before disconnecting any electrical equipment you may encounter while working on the body The car body is a welded...
Body structure and sub-frame — maintenance The condition of your car's body is very important, since its resale value greatly depends on it. It is much more difficult to restore a poorly maintained or damaged...
Upholstery and rugs — maintenance It is recommended to regularly clean sand from mats with a vacuum cleaner. If they are very dirty, they are removed from the machine for washing and cleaning. Place them...
Door hinges, locks and latches — maintenance 1 Regularly lubricate the hinges of the hood, trunk lid, or rear door, and doors with a few drops of thin oil. 2 At the same time, lightly lubricate the hood release...
Seat Belts — Maintenance 1. All models are equipped with diagonal seat belts in the front and rear seats, with three-point fastening and inertia reels. The place in the middle of the rear seat...
Minor body damage — repair Note: The color insert illustrates the body structure restoration sequence described in detail in the following subsections. Repair of minor scratches in body structure...
Body repair — serious damage Where there is serious damage, welding and replacement of parts is necessary - leave this to the professionals. If the damage occurred due to a collision, then it is...
Hood — removal and installation 1. While holding the hood open, place the guard (rags or cardboard) at the bottom of its corners and above the front fenders so as not to damage the paint. 2. Disconnect...
Spoilers — removal and installation Turbo (early models) - front 1. Turbo models built before May 1988 are equipped with a three-piece front air spoiler (see fig. 11.4). 11.4. Installing the front spoiler...
Bumpers — removal and installation Front Pic. 11.8. Front bumper: 1. Outer section; 2. Bracket; 3. Union nut; 4. Steel inner section; 5. Nut; 6. Side bracket of outer half; 7. Outer half side bracket; 8....
Front fender — removal and installation 1. Remove the front bumper ( see Chapter 12 of this Section ). 2. Remove the front spoiler or apron panel as equipped ( see Chapter 11 of this Section ). 3. Remove the...
Mudguards and shields — removal and installation Front mudguards 1. The front mudguards are secured with three screws, cutting threads in plastic union nuts. Rear mudguards 2. The rear mudguards are secured with four...
Washing system — description 1. The pump motor is located at the base of the tank. 2. A level sensor, which activates a warning light on the instrument panel when the flushing fluid drops to the...