25.1. Remove the power window reinforcement and armrest hanger to remove the sealing barrier
2. Check that the connectors are connected correctly, then disconnect all electrical wiring and remove it from the door.
3. Disconnect the control rod by pushing the pin upward (see photo).
25.3. Front door check stop and pin
4. Support the door on wooden blocks.
5. Remove the snap rings and push out the pivot pins (see photo).
25.5. Rear door upper hinge
6. Remove the door from the car. If necessary, the hinges can be unscrewed from the door pillars.
7. Assembly is carried out in reverse order. but at the same time lubricate the hinge pins and check the pin (see photo).
25.7. Front door impact plate