Removing
1. Disconnect the battery from the ground.
2. Remove the air filter.
3. Press on the clips and disconnect the connectors from the throttle potentiometer, air bypass valve, flow meter and idle speed corrector valve.
4. Disconnect the drive cable from the throttle valve, loosen the nuts and remove the cable sheath from the bracket.
5. Disconnect the kick-down cable (on vehicles with automatic transmission).
6. Label all vacuum and air hoses and disconnect them from the damper body.
7. Disconnect the coolant hoses from the damper body by quickly plugging them.
8. Turn away bolts (indicated by arrows) and remove the throttle body and gasket.
9. Plug the hole in the manifold.
Installation
1. Installation is carried out in the reverse order.
2. Clean the split surfaces, replace the gasket and tighten the bolts in 2 steps to the specified torque.
3. Check the correct connection of hoses and wires, in the reliability of their fastening.