Car front and rear suspension Nissan Sunny 7 (B13)

Suspension and steering — general information
Front suspension Consists of levers, racks, stabilizer and crossbar. The crossbar is bolted to the body. The levers are connected to the trunnions by ball joints. Rear...

Suspension and steering technical data
Front suspension Type Independent, lever, with two pillars and anti-roll bar Rear suspension Type Independent, lever, with longitudinal bars and two struts, a stabilizer...

Front wheel bearings — removal and installation
Removing 1. Raise the front of the car and place on stands. 2. Remove the wheel. 3. Remove disc and caliper. 4. Remove the speed sensor (on vehicles with ABS). 5. Loosen...

Front suspension strut — removal and installation
Shock absorbers racks change only in pairs. Removing 1. Raise the front of the car and place on stands. 2. Remove the wheel. 3. Disconnect the hydraulic drive tube from...

Lower arm — removal, inspection and installation
Removing 1. Raise the front of the car and place on stands. 2. Remove the wheel. 3. Loosen the nut securing the stabilizer link to the lower control arm. 4. Loosen two...

Lower arm ball joint
If the ball joint is worn or damaged, then the lever assembly is replaced, as it is a non-separable structure.

Stabilizer bar of the front suspension
Removing 1. Raise the front of the car and place on stands. 2. Remove the wheel. 3. Loosen the nut securing the link to the stabilizer bar (A - nut for attaching the...

Rear wheel bearings — replacement
Bearings are changed only in assembly with the hub. 1. To remove the hub, lift the rear of the vehicle and place it on stands. 2. Remove the wheel. 3. On vehicles with...

Rear suspension strut — removal and installation
Removing 1. Raise the rear of the car and place on stands. 2. Remove the wheel. 3. Loosen the stabilizer link nut on the strut. 4. Disconnect the ABS harness from the...

Rear suspension arms — removal, inspection and installation
Removing 1. Raise the rear of the car and place on stands. 2. Remove the wheel. 3. Loosen axle nuts (indicated by an arrow) levers on the hub housing. 4. If the levers...

Rear suspension bars — removal, inspection and installation
Removing 1. Raise the rear of the car and place on stands. 2. Remove the wheel. 3. Loosen the stem nut on the hub housing and remove the washer. 4. Loosen the nut...

Rear hub housing — removal, inspection and installation
Removing 1. Raise the rear of the car and place on stands. 2. Remove the wheel. 3. On vehicles with rear disc brakes, remove the disc and caliper without disconnecting...

Stabilizer bar of the rear suspension
Removing 1. Raise the rear of the car and place on stands. 2. Remove the wheel. 3. Loosen the nuts (indicated by an arrow) fastening rods to the rack. 4. Loosen the...