Removing
1. Disconnect the battery from the ground.
2. Remove the center section of the front panel (see subsection 13.25).
3. Fully release the handbrake.
4. Disconnect a socket from the switch of a control lamp.
5. Turn away a nut and disconnect an adjusting bolt from the lever.
6. Pre-calculate the number of threads to the nut.
7. Loosen the two bolts and remove the lever.
Installation
1. The lever is installed in reverse order.
2. Loosen the nut by the pre-calculated number of threads, check the operation of the brake and adjust if necessary.
3. Before installation of the panel check up serviceability of the switch and a control lamp.