Removing
1. Open the hood, mark the position of the hinges on the hood.
2. Release the washer hose from the brackets by disconnecting from the fitting.
3. Loosen the hinge bolts and remove the hood with an assistant.
4. Check the play of the axles in the hinges, if necessary, unscrew the two bolts and replace the hinges.
Installation
1. Install the hood, align with the marks on the hinges and tighten the bolts.
2. Attach the hose and lay in the brackets.
3. Adjust the hood.
Adjustment
1. Close the hood and check the gaps with adjacent body panels. If necessary, loosen the hinge bolts and adjust the position of the hood, tighten the bolts.
2. After adjusting the hood, check the operation of the lock and adjust. The latch of the lock should work when the hood is below the edge of the wing by 1.0–1.5 mm. Loosen the lock bolts, adjust the position and tighten the bolts.
3. If necessary, adjust the position of the front edge of the hood in height by rotating the rubber buffers screwed into the front partition of the body.