Lock
1. Disconnect the latches along the contour of the cover and remove the inner panel.
2. Disconnect the latches from the lock cover.
3. Get and take away in a cover a socket of the switch of illumination of a luggage carrier.
4. Unscrew the two bolts and remove the lock from the cover.
5. Release the link by turning the key in the lock and pass the switch connector.
6. Disconnect the connector and remove the lock.
7. Install the lock in reverse order.
Trunk lock switch
1. Remove the decorative panel.
2. Get a lock ring and disconnect from the switch draft of a drive of the lock.
3. Get a bracket and remove the switch. Install the switch in reverse order. Install the switch in reverse order.
Retainer
1. Disconnect the seal and trim.
2. Remove the carpet pad.
3. Mark the position of the latch, unscrew the two bolts, remove the latch and disconnect the lock drive cable from the lever.
4. Install the retainer in reverse order. before installing the lining, check the operation of the lock.