Glass
1. Remove the panel and screen.
2. Install the power window handle (or connect the switch connector, connect the battery to ground).
3. Lower the glass so that the glass holder bolt is in the hole in the door frame.
4. Supporting the glass, unscrew the bolts securing the glass to the holder (indicated by arrows). Coupés have an extra bolt that secures the glass to the front track roller.
5. Get the glass through the opening.
6. Glass is installed in reverse order. When installing, make sure that the seal does not fall behind. Before installing the panel, check the operation of the power window.
Power window (hatchback and sedan)
1. Disconnect the glass from the power window (see above).
2. Raise glass and secure with tape or wedges, or remove.
3. Disconnect the drive connectors (if provided).
4. Turn away bolts of fastening of a manual drive of a window regulator (or electric drive) (indicated by arrows).
 |  |
5. Unscrew the top (photo on the left) and lower (photo on the right) window regulator bolts and remove the regulator through the window opening. The electric drive with cables comes with the regulator. Pre-designate the location of the detachable parts.
6. The window lifter assembly with the regulator and the drive is installed in the reverse order. Before installing the panel, check the operation of the power window.
Coupe
1. Disconnect the glass from the power window.
2. Disconnect the drive connectors.
3. Remove the power window bolts.
4. Turn away bolts of both directing and remove window regulator in gathering. Pre-designate the location of the detachable parts.
5. The window regulator is established upside-down. Before installing the panel, check the operation of the power window.
Tailgate window corner - 5 door hatchback
1. Remove the glass lift section.
2. Turn away bolts and remove a back guide, supporting a corner.
3. Carefully remove the corner with the seal.
4. Remove the seal from the corner.
5. The corner is installed in the reverse order.