Removing
Description of works
Removing the center beam is necessary to remove both the front and rear ACMs. However, if it is not necessary to remove the ACM, leave it on the engine. The procedures for removing both ACMs are described below.
1. Remove the following parts: engine underbody protection, air duct and air cleaner housing, intercooler. Then disconnect the automatic transmission control cable from the transmission and move it to the side.
2. Disconnect the front side ACM wiring connectors as described below.
(1) Disconnect the three wiring connectors on the gearbox side and remove the bracket.
(2) Remove the connectors and wiring harness from the bracket.
(3) Remove the two wire ties from the front engine mount bracket.
3. Disconnect the rear side ACM wiring connectors as described below.
(1) Disconnect the three wiring connectors from the side of the rear rack and remove the rack.
(2) Remove the connectors and wiring harness from the rack.
4. Loosen the top two ACM mounting nuts on the front and back.
5. Disconnect connecting wires (1 pc.) ACM from the front and rear side of the body.
6. Support the engine oil pan with a jack and remove the ACM from the front and rear sides together with the center beam.
Attention: Be sure to disconnect the connectors and remove the wiring ties so as not to break the wires during removal.
7. Disconnect connecting wires (1 pc.) ACM from the front and rear side of the central beam.
8. Loosen the ACM's three lower mounting nuts at the front and rear sides and remove the ACM from the center beam.
Attention:
Do not drop the ACM or subject it to impact. If this happens, replace the ACM.
Hold the ACM by the body, not by the wiring or connector.
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
Install the ACM, paying attention to the mark on the right side.
- ACM label on the front side: F
- ACM label on the back side: R2
Example:ACM from the front:
Firmly install and secure the wiring and connectors, see section «Withdrawal».
Attention:
Be careful not to damage the wiring and connectors when installing on a bracket or center beam.
After installation, adjust the vibration level.