Removing
1. Remove the following components:
- Engine protection from the bottom
- Mudguard right wheel
- Drive belts
2. Drain the coolant from the radiator and cylinder block.
3. Support the bottom of the oil pan with a floor jack and remove the right engine mounting insulator (from the front of the engine).
4. Remove the water pump pulley.
Fix the pulley with a screwdriver and unscrew the set screws.
5. Remove the motor mounting bracket.
6. Remove the water pump.
Examination
Check body and blades for corrosion and contamination.
Make sure the pump shaft rotates freely without play.
Replace water pump if necessary.
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
Apply Three Bond 1207C Sealant (KR51000150) on the water pump housing as shown in the figure.
Install the water pump with the front mark (white color) toward the front of the engine, see fig.