Removing
2WD Models
1. Turn off the top fixing nuts of connecting drafts of the stabilizer of cross-section stability.
2. Turn off fixing bolts of clips of the stabilizer.
3. Remove the steering gear, see Sec. Steering.
4. Remove the anti-roll bar from the vehicle.
4WD Models
1. Follow paragraphs. 1-11 for removing the front suspension beam.
2. Lower the jack so that you can remove the stabilizer from the suspension beam.
3. Turn off the top fixing nuts of connecting drafts of the anti-roll bar.
4. Turn off fixing bolts of clips of the stabilizer and remove it from the car.
Examination
Check stabilizer, tie rods and clamps for deformation, cracks or damage and replace if necessary.
Installation
Installation is carried out in the reverse order of removal.
The stabilizer uses connecting rods with ball-type liners. Install the ball joint body on the spherical support of the liner parallel to the stabilizer.
