Preparatory work
Remove the front and rear sill plates.
Remove the lower finishing of the central rack.
Remove the front seat belt (seat belt pretensioner).
Attention:
Before removing, turn the ignition key to the OFF position, disconnect both cables from the battery and wait at least 3 minutes.
When carrying the sensor, do not grasp the wires.
When installing, do not pinch or damage the wires.
If the sensor has been dropped or hit, replace it.
After installation, check if the system is working properly by observing the airbag warning light.
If the airbag warning lamp indicates a malfunction, use the self-diagnosis function or the CONSULT tester to clear the memory.
If the airbag warning light still indicates a malfunction, run system diagnostics. Repair defective components.
If deployed, replace the front seat side airbag module.