Car clutch repair Nissan Qashqai 1 (J10)

Precautionary measures
Attention. Clutch uses Genuine Nissan Brake Fluid or equivalent DOT 3 or DOT 4 (mixing of different types of brake fluid is not allowed). Do not reuse drained clutch...

Clutch pedal
Examination 1. Visually verify that the clutch master cylinder rod end moves freely without binding. If the rod tip does not move freely, remove it from the clutch pedal...

Clutch hydraulic drive working fluid
Checking the clutch fluid level Make sure the fluid level in the reservoir is between the marks «MAX» And «MIN». Visually inspect for signs of leakage around the clutch...

Clutch pedal — device
1. Clutch pedal assembly. 2. Cruise control switch (ASCD). 3. Clamp. 4. Pedal pad.

Clutch pedal — removal and installation
Removing 1. Remove the inner trim of the front panel and the side trim of the instrument panel. 2. Remove the bottom of the instrument panel from the driver's side. 3....

Clutch master cylinder — device
1. Expansion tank assembly. 2. Hose. 3. Clutch master cylinder assembly.

Clutch master cylinder — removal and installation
Removing Attention. Do not allow brake fluid to come into contact with the vehicle's paintwork. If this occurs, immediately remove the brake fluid from the surface and...

Clutch hydraulic lines — device
RS5F92R: 1. Concentric clutch release cylinder (CSC). 2. Hydraulic pipeline. 3. Bracket. 4. Hydraulic damper. 5. Clutch master cylinder. RS6F94R: 1. Concentric clutch...

Clutch hydraulic lines — removal and installation
Attention. Do not allow brake fluid to come into contact with the vehicle's paintwork. If this occurs, immediately remove the brake fluid from the surface and flush the...

Concentric Release Cylinder — Device
HR16DE, MR20DE and K9K: 1. Gearbox assembly. 2. Concentric release cylinder assembly. M9R: 1. Gearbox assembly. 2. Concentric release cylinder assembly. 3. Mounting...

Concentric release cylinder — removal and installation
Attention. Every time the transmission is removed from the vehicle, the concentric release cylinder must be replaced with a new one. Move the concentric clutch release...

Clutch work and pressure plates — device
Engines HR16DE, MR20DE: 1. Flywheel. 2. Clutch disc. 3. Clutch basket. 4. Transmission input shaft. A. First stage tightening (MR20DE engine). B. First stage tightening...

Working and pressure disks of coupling — removal
1. Remove the gearbox assembly from the vehicle (see chapter « Gearbox »). 2. To turn away bolts of fastening of a pressure plate of coupling. 3. Remove the clutch...

Clutch work and pressure plates — check after removal
Clutch working disc 1. Measure the play of the clutch disc but the splines of the input shaft. If the value obtained exceeds the established norm (see «Service data and...

Clutch work and pressure plates — installation
1. Clean the splines of the clutch disc and gearbox input shaft to remove grease and wear products. 2. Apply the recommended grease to the splines of the clutch disc and...

Service Data
Clutch drive system Type of clutch drive - hydraulic. Clutch pedal Gap "A" between the clutch pedal and the end face of the ASCD sensor with the clutch pedal fully...