Vehicle fuel system Nissan Qashqai 1 (J10)

General security measures
Attention. When replacing fuel line elements, follow the instructions below: Make sure the area is well ventilated and has a carbon dioxide fire extinguisher. Do not...

Precautions when working with the power supply system of gasoline engines
You must use gasoline with the correct octane rating. Perform the following procedures before removing fuel lines: Collect the drained fuel in an explosion-proof...

Precautions when working with the diesel engine power system
Diesel fuel with the appropriate cetane number must be used. Perform the following procedures before removing fuel lines: Collect the drained fuel in an explosion-proof...

Checking the condition of the fuel lines
Check the fuel lines, filler cap, and fuel tank for improper fastening, leaks, cracks, damage, loose connections, chafing, and wear. If necessary, repair or replace...

Fuel filter (modifications with K9K diesel engine)
1. Fuel filter. 2. Fuel filter bracket. 3. Fuel filter protection. Fuel filter replacement 1. Remove the pumping bulb from the bracket. 2. Remove the fuel filter from...

Fuel filter (modifications with M9R diesel engine) — device
1. Pumping pear. 2. Fuel filter. 3. Fuel hose. 4. Fuel filter bracket. 5. Fuel filter protection. A. To a centralized underground fuel line. B. To the fuel pump. C. To...

Removal and installation of the fuel filter (modifications with diesel engine M9R)
1. Disconnect the quick connectors and remove the fuel hoses. Attention. Avoid splashing fuel during removal. If fuel is splashed, remove it immediately. 2. Remove the...

Fuel Gauge Sensor Module — Device
Versions with gasoline engines and front-wheel drive (2WD): 1. Locking ring. 2. Sensor module for fuel gauge, fuel filter and fuel pump. 3. The sealing ring of circular...

Fuel Gauge Sensor Module — Removal
Attention. Before starting work, you must carefully read the precautions for working on the car's power system. Note. Below is a description of the procedures for the...

Fuel Gauge Sensor Module — Installation
Installation is carried out in the reverse order of removal, taking into account the following remarks: 1. Fuel priming pump module with main fuel level sensor and fuel...

Fuel tank — device
Versions with petrol engine and front wheel drive (2WD): 1. Filler cap. 2. Seal. 3. Filling pipeline. 4. Cover. 5. Collar. 6. Filling hose. 7. Collar. 8. Right fuel tank...

Removal and installation of the fuel tank
Removing 1. Remove fuel level sensor, fuel filter and fuel pump module (see previous section). 2. If necessary, drain the fuel from the tank. Attention. Since the fuel...

Fuel Cut Control for Gasoline Engines
If the idle speed of the cranked motor exceeds 2,500 rpm (e.g. selector lever is in neutral position and crankshaft speed exceeds 2,500 rpm) the fuel supply must be cut...

On-Board Diagnostic (OBD) system for engine and automatic transmission
Electronic engine control unit (ECM) equipped with an on-board diagnostic system. In the event of a deterioration in the efficiency of the emission control devices, this...

Diesel engine service data
Idle frequency Note. *: the subject state means the air conditioner is turned off, electrical appliances are turned off (rear window lighting, ventilation and heating)...