Electrical equipment of the car engine Nissan Primera 1 (P10)

Engine Electrical System Specifications
Note. Separate characteristics are also given in the text of the Chapter and, if they are mandatory, are highlighted in bold Ignition system Design works with the...

Engine electrical equipment — general information
The electrical equipment of the engine includes all components of the ignition, starting and charging systems. Due to the fact that, according to their functional...
There is 1 comment

Ignition system — general information
As already mentioned, the ignition system works on a carbureted engine with an electronic control device or with an injection system. Only on carbureted engines without...

Ignition distributor — removal, installation and repair
Distributor maintenance The distributor cap should be cleaned inside and out at regular intervals to remove carbon deposits, dust or moisture. Also clean the distributor...

Ignition timing adjustment
Although the ignition timing is automatically adjusted, it can also be adjusted manually. The preparatory work is the same as when adjusting the idle speed for the...

Spark plugs — general description
Spark plugs have a thread with a diameter of 14 mm. Manufacturers recommend a certain type of spark plug, but suitable spark plugs with the appropriate heat rating from...

Charge and launch systems — general information
All vehicles covered in this manual have a 12V electrical system. The ground connection is through the negative battery terminal. The battery is located in the engine...

Battery — removal, installation and maintenance
The installed 12V battery consists of six jars containing positive and negative plates, which are dipped in a sulfuric acid solution. The task of the battery is to...

Precautions when working on the charging system
Before doing any work on the charging system, you should familiarize yourself with the following safety precautions: 1. Never disconnect the battery or voltage regulator...

Generator — removal, installation and check
Checking the installed generator During normal driving, the charge control lamp should go out. Otherwise, the fault lies in the generator or voltage regulator. First,...

Generator repair
The generator and the regulator connected to it should not be adjusted or repaired if there is no necessary experience. A generator that does not charge the battery can...

Starter — removal and installation
Primera models have a positive gear starter that matches the power of the engine. The 1.6L engine starter has a direct drive, i.e. the starter power is transferred...

Disassembly and assembly of the starter
The illustration below shows the wiring diagram for a low speed starter. Reverse Starter Front Wiring Diagram 1 - bolts, 6 Nm; 2 - front bearing shield; 3 - starter...

Starter Parts Check
Brushes The brushes must be 5 mm long (with reduction gear) or 3.5 mm (with direct drive). You can use a caliper to measure the brushes. 1. Check that the brushes move...

Starter Assembly
The starter is assembled in the reverse order of disassembly. 1. Lightly lubricate the gearing of the armature shaft and the engagement lever bearing with grease. 2....