Brake system of the car Nissan Primera 1 (P10)

Brake Specifications
Note. Separate characteristics are also given in the text of the Chapter and in case of obligation and their implementation are highlighted in bold Design 1.6 l front...

Brake system — general information
The location of the brake lines on a car without ABS 1 - front brakes; 2 - rear brakes; 3 - main brake cylinder; 4 - pressure regulator The location of the brake...

Replacing the front brake pads
Details of the brake system are shown in the illustration. It should be followed in future work. It is necessary to take into account the differences between the two...

Front brake caliper repair
1. Remove the brake pads. 2. Unscrew the brake pipeline from a support. It is connected by means of a hollow bolt with two copper washers. Washers should always be...

Front brake discs — removal and installation
Brake discs are removed together with the hub. These works have already been described in Section "Take out the caliper..." . Then remove the brake disc from the hub and...

Rear drum brakes
Replacement of brake pads Wiring diagram for rear drum brakes. The big arrow points to the front of the car 1 - bleed valve, 5-8 Nm; 2 - brake pipeline with union nut,...

Rear disc brakes
Loosen both bolts indicated by arrows to remove the handbrake cable attachment. Replacement of brake pads 1. Raise the rear of the vehicle. 2. Remove wheels. 3. Remove...

Master brake cylinder — removal, installation and repair
Removal and installation Wiring diagram of the main brake cylinder. The bottom right shows the cylinder in the case of ABS installed 1 - cover; 2 - compensation tank; 3...

Bleeding the brakes
Bleeding the brakes is required if the system has been opened in any place, or air has entered it in another way. Before bleeding the brakes, remove dirt and foreign...

Brake booster
Repair of the brake booster is not carried out, since special tools are required for disassembly and assembly. The failure of the amplifier does not mean the loss of...

Control valve
The brake pressure control valve is installed either in the wheel brake cylinders (with drum brakes), or two valves are installed on the lower part of the body and are...

Hand brake
Brake booster in the case of an installed ABS system 1 - nut, 8-11 Nm; 2 - brake booster; 3 - cotter pin; 4 - cotter pin; 5 - nut, 13-16 Nm Location of handbrake cables...

Brake adjustment
Service brakes Disc brakes on the front wheels and disc or drum brakes on the rear wheels are automatically adjusted so no adjustment work is required. When the brake...

Anti-lock braking system (ABS)
Hydraulic circuit anti-lock system (ABS) 1 - front left caliper; 2 - main brake cylinder; 3 - rear left caliper; 4 - hydraulic control device; 5 - front left control...