Removing
Note. Transmission removal and installation procedures are the same as above for models 4.2 l subject to the points listed below.
1. After removing the assembly of the gear lever with the shift drive housing, use a special magnet to remove the spring and ball from the extension housing.
2. At removal of the executive cylinder of coupling give bolts of fastening of an arm of a hydraulic tube to the engine.
Installation
1. When installing the shift housing assembly with shift lever, lubricate its mating surface with Loctite 587 sealant (or its equivalent).
2. Don't forget to reinstall the spring and ball. Mounting bolts with 12 mm heads screw in positions A, 13 mm - in positions B (see accompanying illustration). Tighten all fasteners to the required torque.