Rear axle and vehicle suspension Nissan Patrol 4 (Y60)

Rear axle and suspension — general information
The rear axle is equipped with a crankcase "banjo", inside which the hypoid assembly of the main gear and semi-unloaded axle shafts are located. All models with hardtop...

Semi-axle service — removal and installation
Note. To replace the bearing, you will need a 58.2 mm tubular wrench and a press with backing plates. Note. To lubricate all, a lithium-based general purpose grease...

Final drive assembly service
Note. The following special tools are required for the following procedures: Stillson wrench and pinion flange puller (to replace the drive gear oil seal); the tools...

Rear axle assembly service
Models Hardtop (Hardtop) and Universal (Station Wagon) Removing 1. Loosen rear wheel nuts. 2. Jack up the rear of the vehicle and place it on jack stands placed under...

Servicing shock absorbers (spring suspension)
Removing 1. Jack up the rear of the vehicle and place it on jack stands under the rear axle housing. 2. Give a nut of fastening of the top end of the shock-absorber to...

Maintenance of rear suspension springs
Removing Details of fastening of a spring of a back suspension bracket 1 - bushings; 2 - washer; 3 - nuts; 4 - earring plate; 5 - leaf springs; 6 - U-shaped bolts of the...

Servicing shock absorbers (spring suspension)
Removing 1. Jack up the rear of the vehicle and place it on jack stands under the chassis frame. Raise the rear axle housing with a jack under its central part. It is...

Removal and installation of helical springs of a back suspension bracket
Note. The following procedures require a special coil spring compression tool. Removing Rear Suspension Coil Spring Components 1 - saddle 2 - spring 1. Jack up the rear...

Removal and installation of a transverse torque rod (spring suspension)
Note. The following procedures require a press, suitable mandrels and pipes. Removing 1. If necessary, jack up the rear of the vehicle and place it on jack stands under...

Removal and installation of longitudinal reactive suspension rods (spring suspension)
Note. The following procedures require a press, suitable mandrels and pipes. Removing Upper torque arm 1. Jack up the rear of the vehicle on the appropriate side and...

Removal and installation of the stabilizer bar (spring suspension)
Removing 1. Jack up the rear of the vehicle and place it on jack stands under the rear axle housing. 2. Loosen the nuts securing the boom legs to the chassis brackets...

Removal and installation of assembly of the mechanism of deactivation of the rear anti-roll bar
Removing Components of the rear anti-roll bar disengagement drive 1. Jack up the rear of the vehicle and place it on jack stands under the axle housing. Move the...