Removing
1. Give the screw of fastening of facing of the handle of the remote drive of the lock to the panel of a door. Remove the cover.
2. On manual up/down models, remove the power window handle using the detent tool. If this tool is not available, pry off the facing plate of the handle with a thin, strong wire bent at the end in the form of a hook. Lower the hook into the latch under the drive handle and, pulling the wire, remove the latch from the end of the handle, then remove the handle from the door. Alternatively, the handle can be removed with a strong cloth placed under it. To remove the retainer, pull firmly on the corners of the fabric.
3. On models with a separate armrest, loosen the fixing screws and remove the armrest from the door.
4. On models with power windows with individual switches, remove the switch from the door trim panel and disconnect its electrical connector. Be careful not to damage the switch panel.
5. On models with a power window switch built into the armrest, proceed as follows:
- Remove a finishing overlay from the bottom part of the grasping handle of a door and give the screws located under it. Using a flat-blade screwdriver, carefully pry the grip handle and remove it from the armrest assembly.
- Using a flat-blade screwdriver, carefully pry the power window switch panel and remove the latter from the armrest assembly. Disconnect the electrical connector and move the switch panel away from the work area.
- Give screws of fastening of an armrest to the internal panel of a door. Leave the armrest connected to the door trim panel.
6. Insert a screwdriver with a thin wide flat blade between the trim panel and the door frame as close as possible to one of the clips. Prying off, alternately remove the trim panel fasteners. Remove the panel from the door (tailgate with trim panel and sealing film removed, shown in accompanying illustration).
7. Carefully remove the plastic sealing film from the inner door panel.
Installation
Installation is in the reverse order.
1. Follow the correct placement of the polymer sealing film on the door panel. A torn or otherwise damaged film should be replaced.
2. Replace damaged trim panel clips.
3. Carefully install the trim panel on the door, snapping the latches one by one.
4. On models with a manual drive for lowering and raising windows, install the window handle trim, the handle itself and its retainer on the door. Make sure that the relative position of the handle and window glass correspond to that of the opposite door.
Note. The power window handle retainer must be installed in the handle before the latter is put on the adjuster shaft trunnion.