Removing
Door Lock Drive Components
1 - lock off button; 2 - screw; 3 - lining of the inner handle; 4 - internal handle of the remote drive of the lock; 5 - guide; 6 - outer door handle; 7 - latch; 8 - sealant; 9 - nuts; 10 - drive rod; 11 - executive rod; 12 - lock lever; 13 - lock; 14 - drive lock of the lock off button
1. Remove the interior door handles, trim panel and plastic sealing film.
2. Give screws of fastening of the internal handle of the remote drive of the lock of a door to the internal panel of a door.
3. Disconnect the remote actuator stem from the lock. Remove the stem with the handle from the door.
4. Disconnect the stem of the off button from the lock.
5. On models with a central lock, disconnect the actuating rod of the drive motor from the latch.
6. Give screws of fastening of the mechanism of the lock to a door. Remove the lock mechanism from the door through the access hole.
Installation
Installation is in the reverse order.
1. Lubricate the lock mechanism with multipurpose grease before installation.
2. Turning the nut on the actuating rod of the outer door handle, adjust the gap between the nut and the lock lever - with the handle released, the gap should be 0.5÷1.5 mm.
3. Before reinstalling the polymer sealing film and the door trim panel, check the proper functioning of the lock and power window mechanisms.