Front cable
1. Release the brake lever.
2. Disconnect the cable from the lever (photo).
18.2 Terrano I/Pathfinder hand brake actuator parts 1. Rear cable 2. Adjuster 3. Front cable
3. If necessary, raise the rear of the vehicle and place it on stands.
4. Loosen the nut and disconnect the opposite end of the cable from the balance arm (on all-wheel drive vehicles) or from regulator (on rear-wheel drive vehicles).
5. Disconnect the rear left cable from the front.
6. Turn away bolts of the equalizing lever.
7. Disconnect all clamps and remove the front cable and leveling arm.
8. Installation is carried out in the reverse order. Lubricate all moving parts.
Rear cable
9. Release the brake lever.
10. Turn away a nut and disconnect a cable from an equalizing lever (on all-wheel drive vehicles) or from regulator (on rear-wheel drive vehicles).
11. Disconnect the rear left cable from the front.
12. Disconnect the tips of the rear cable from the rear brakes and get the tips through the holes in the brake shield.
13. Loosen the clamps and remove the cables.
14. Installation is carried out in the reverse order. Lubricate all moving parts.