Attention! The regulator is non-separable and must be replaced in case of failure.
1. Loosen the fittings and plug the holes in the pressure regulator.
2. Turn away bolts and remove a regulator (photo).
3. If the regulator will change, then remove the bracket.
4. Installation is carried out in the reverse order.
5. Bleed the brakes.
11.2a Type A brake pressure regulator
1. Connection for pumping; 2. Bracket; 3. Pressure regulator (inseparable)
11.2b Type B brake pressure regulator
1. Connection for pumping; 2. Pressure regulator (non-separable); 3. Bracket; 4. Spring