Car clutch and drive shafts Nissan Maxima 4 (A32)

Clutch and drive shaft specifications
Clutch Type Single disc, dry with hydraulic drive (Torque converter with the possibility of blocking on models with AT) Type of hydraulic fluid see chapter Settings and...

General information about the clutch and drive shafts
This chapter is about the components located between the rear of the engine and the front (leading) car wheels. According to their purpose, the components under...

Clutch — general information and checking the condition of the components
Clutch Assembly Components 1 - Nut (8÷11 Nm); 2 - Main cylinder; 3 - Nut (16÷22 Nm); 4 - Bolt for fastening the pedal support bracket; 5 - Bolt of fastening of an...

Removal and installation of the clutch master cylinder
Clutch Master Cylinder Assembly Components 1 - Housing; 2 - Hydraulic fluid reservoir; 3 - Tank cover; 4 - Return spring; 5 - Sealing cuffs; 6 - Piston; 7 - Valve stop...

Removal and installation of the clutch slave cylinder
Clutch Slave Cylinder Assembly Components 1 - Housing; 2 - Piston spring; 3 - Piston cover; 4 - Piston; 5 - Pusher rod; 6 - Boot; 7 - bleed valve (6÷10 Nm) Removing 1....

Removal of air from the hydraulic path of the clutch release drive
1. Bleeding the hydraulic shutdown actuator should be performed each time its components are removed, and also when the fluid level in the master cylinder reservoir...

Removal, condition check and installation of clutch assembly components
Warning! Remember that the dust produced during the wear of the friction linings of the clutch disc may contain asbestos, which is harmful to health. Do not blow off...

Removing, checking the condition and installing the release bearing and clutch release lever
Warning! Remember that the dust produced during the wear of the friction linings of the clutch disc may contain asbestos, which is harmful to health. Do not blow off...

Clutch pedal adjustment
Clutch Pedal Height Measurement (H) 1 - Pedal support bracket; 2 - Stopper for adjusting the full stroke of the pedal; 3 - Pedal shoe pad; 4 - Floor panel; 5 - Polymer...

Check of serviceability of functioning and replacement of the gauge switch of opening of a chain of a starter
1. The starter open circuit switch is located near the upper end of the clutch pedal. 2. Check the correct setting of the pedal height and pusher free play (see Section...

Drive shafts — general information and condition check
The transmission of torque from the transmission to the drive wheels of the vehicle is carried out by means of drive shafts. The inner ends of both shafts enter directly...

Removal and installation of power shafts
Drive shaft components 1 - Bandages for fastening protective covers; 2 - Drive shaft; 3 - Protective cover; 4 - Retaining ring; 5 - Inner clip of the inner CV joint; 6 -...

Checking the condition and replacing the thrust bearing assembly
Note. The procedure applies only to the assembly of the right drive shaft. 1. Remove the right drive shaft assembly (see Section Removal and installation of power shafts...

Replacing protective covers and checking the condition of CV joints
Note. If defects in the protective cover are detected, the condition of the corresponding CV joint must be carefully studied. Often, fully remanufactured driveshaft...