Warning! The vehicles covered in this manual are equipped with the SRS Supplemental Safety System, better known as the airbag. Before doing any work near the pillow assembly or steering column, be sure to turn off the system to avoid injury as a result of accidental operation, - disconnect the negative first, then the positive cable from the battery and wait at least two minutes before proceeding with maintenance of components located near directional g-force sensors (see chapter Onboard electrical equipment). The insulation and connectors of the SRS wiring harness are bright yellow. Do not connect any diagnostic devices to this circuit!
1. Remove the central facing of the instrument panel (see chapter Body).
2. Turn out four screws of fastening of assembly of management to the panel of devices.
3. Remove the assembly from its seat in the panel and disconnect the electrical wiring.
4. For a description of the procedures for checking the switch for selecting the speed modes of the heater fan, see Section Checking the proper operation of the heater fan drive electric motor and the condition of the components of its electrical circuit. To remove the switches from the panel, it is necessary to remove the handles from the levers, unscrew the four screws securing the circuit board casing, then press the plastic locking tabs from the back of the corresponding switch and release it from the panel.
5. Installation is carried out in the reverse order.