2. Remove the brake disc/drum (see chapter Brake system).
1 - hub flange
2 - Wheel nut
3 - Clamp
3. Partially screw the nut onto the stud to be replaced. Press the stud out of the flange of the hub assembly using the special tool.
1 - hub flange
2 - Remote sleeve
4. Thread the stud into the hub flange (on the back of the last), install the spacer/several flat washers and thread the nut onto the stud.
5. Tighten the nut until the stud is fully seated in the flange.
6. Reinstall the brake disc/drum. Lower the vehicle to the ground and tighten the wheel nuts to the required torque (see chapter Settings and ongoing maintenance).