Exterior (external elements) of the car Nissan Maxima 4 (A32)

Body specifications and dimensions
Body geometry Use rolling sensors to achieve correct wheel alignment (the rear wheels must be exactly in the track of the front), - check the correct installation of the...

General information and precautions
Attention! On some models, the front seat belts are equipped with pyrotechnic automatic tensioners that are triggered if the directional overloads exceed a certain...

Car body and underbody care
It should be remembered that the main factor determining the selling price of a used car is the condition of its body. Body panel care procedures are extremely simple,...

Care of vinyl trim elements
Do not use detergents, caustic soda, or petroleum-based cleaners when cleaning vinyl panels. A warm solution of soap and water works well for this purpose. Stubborn dirt...

Repair of minor damage to body panels
Repairing easily scratched paintwork If the scratch is superficial and does not affect the metal of the body panel, the restoration of the paintwork is extremely simple....

Repair of seriously damaged body panels
Such repairs are usually carried out using welding equipment and should be carried out in a car service workshop. In case of extensive damage, first of all, it should be...

Servicing car hinges and locks
Every 5000 km (3000 miles) mileage, or once every three months, the hinges and assemblies of the lock latches of the doors, hood and luggage compartment lid should be...

Removal and installation of a decorative grille of a radiator
1. Open the hood. 2. Release the plastic clips (on some models, bolt pairs are installed instead of clamps) fastening the grille to the assemblies of the block...

Removal, installation and adjustment of position of a cowl
Removing Note. The hood panel has a decent weight, so you should enlist the support of an assistant. 1. Open the hood, then cover the fenders with special pads or just...

Removal and installation of a latch of the lock of a cowl and a cable of its drive
Warning! The car models covered in this manual are equipped with an additional security system (SRS). Before doing any work near the airbag unit, steering column or...

Removal and installation of front and rear bumpers
1. Apply the parking brake, jack up the vehicle and place it on jack stands. 2. Disconnect the negative cable from the battery. Attention! If the stereo system installed...

Removal and installation of front fenders
1. Open the hood. Loosen the wheel nuts, jack up the vehicle and place it on jack stands. Remove the front wheels. Disconnect the negative cable from the battery....

Removal and installation of the front reflector panel
1. With a wax pencil, mark the position of the brushes on the windshield of the car. 2. Remove wiper arms (see Section Removal and installation of front and rear bumpers...

Removal and installation of rear-view mirrors
Outside mirror 1. Remove the door trim panel and insulation film (see Section Removal and installation of panels of an internal upholstery of doors ). 2. On the models...